Description
Broach - Tang Hole Saw for Knife Making with Maple Handle
This tool from Nordic Edge is their version of the tang hole saw, or "broach".
A broach is used when fitting a stick tang blade into a handle block,
by rasping drilled holes into a slit or hole that matches the tang of the blade.
This is the full version with blade fitted into maple wood handle, in box.
The blade is made from stainless steel 5Cr15Mov, a tough and highly corrosion-resistant steel tempered to 56-57 HRC.
The blade is 162.8 mm long including the tang, and about 2.6 mm thick at the teeth.
The sharp section of the blade is about 96 mm x 2.6 mm with the Nordic Edge logo lasered on.
How to use the broach:
- accurately measure the tang cross-section with calipers where the tang will meet the handle block
- scribe these measurements onto the front of the handle block and mark in with a pen
- drill a series of holes smaller than the marked area in a straight line
- use the broach to remove the handle material between the holes to create a slit
- rasp out the rest of the marked area with the broach, stopping often to test fit the blade
Broaches are not a new thing, most of us have some version of this already in our arsenal. Some use a short jigsaw blade fitted in a block of wood, others use a set of small files or wood rasps. This is just their take on the tool, with a blade narrow enough to get into holes 3 mm in diameter for fitting most blades except really thin chef blades, with aggressive teeth for fast stock removal in wood and synthetic handle materials.
The Nordic Edge broach is designed by Nordic Edge in Australia and manufactured in China.